Step down from a 1" main line to 1/4" micro-tubing without tools or extra fittings. The fiberglass-reinforced nylon body and bright blue captive compression nut are the ANKA signature - approved for potable water, non-corrosive in fertilizer and chlorinated lines, and rated 230 PSI at 140 deg F. Used in agricultural irrigation, rural water service, hydroponic systems, marine washdown, and contractor garden-hose work.

• Reduces 1" to 1/4" on ID-sized poly pipe, tubing, or hose
• Fiberglass-reinforced nylon - non-corrosive in fertilizer, chlorine, and saltwater
• Captive blue compression nut hand-tightens; no clamps or tools needed
• Approved for potable (drinking) water service
• Max 230 PSI at 140 deg F; reusable after disassembly
• Connects polyethylene pipe, clear braided vinyl, garden hose, and washdown hose

Large-to-micro transition: 1" main supply or pump discharge stepped down to 1/4" drip-emitter feed, micro-spray lead, or small auxiliary tap. The wide reduction is the size of choice when you need to pull a small accessory line off a primary irrigation manifold without splitting the main run, and it is also common on lab and analytical bench feeds.

Tip: Cut the 1/4" micro-tubing perfectly square and burr-free - even a small angle on the small side will lift the barb seal at pressure. If your main line runs above 30 PSI, add an inline pressure regulator downstream for drip emitters; the ANKA fitting itself handles full 230 PSI, but most 1/4" emitter tubing is rated much lower.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information: www.watts.com/prop65