Narrow-profile carpet trim bar that finishes the raw edge of installed carpet at doorways and transitions to hard-surface flooring (vinyl, tile, hardwood, laminate). The 1-3/8" width suits doorways and tight transitions where the standard 2" profile would overhang or look bulky.

• Material: Stamped aluminum with pewter-finish coating
• Profile width: 1-3/8" (narrower than standard 2" trim; better for tight thresholds and small doorways)
• Length: 36" (single-doorway run; cut down with a hacksaw if needed)
• Finish: Pewter (matte gray-brown that coordinates with most neutral interiors)
• Fastening: Pre-drilled countersunk holes for screw nails (sold separately)
• Use: Carpet-to-tile, carpet-to-vinyl, carpet-to-hardwood transitions; doorway terminations on standard residential carpet
• Compatible with: Cut-pile or low-loop residential carpet up to roughly 3/8" pile height

Installation Tip: Tuck the raw carpet edge under the open hem, then drive screw nails through the pre-drilled holes into the subfloor. For concrete subfloors, drill 1/4" pilot holes and set lead or plastic anchors. Cut to length with a fine-tooth hacksaw and dress the cut with a metal file.

Color match Tip: Pewter coordinates with brushed-nickel and oil-rubbed-bronze door hardware, gray-tone tile and grout, weathered wood floors, and modern-farmhouse or transitional interiors.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.