Coleman Cable 20/2 thermostat wire is designed for low-voltage HVAC control wiring between the thermostat, furnace, air handler, and condenser. Features 2 solid bare copper conductors with color-coded PVC insulation and a smooth brown PVC outer jacket that resists snagging during long pulls through joists, wall cavities, and crawlspaces. Also serves doorbells, chimes, irrigation valves, security panels, and other 24 V Class 2 control circuits.

• 20 AWG solid bare copper conductors
• 2 conductors, color-coded PVC insulation under a brown PVC outer jacket
• CL2 rated per NEC Article 725 (Class 2 Power Limited Circuit Cable, max 30 V, 100 VA)
• Smooth round jacket eliminates snagging during long pulls and easy strip-back for terminations
• For indoor general-purpose runs; not rated for direct burial, wet locations, or return-air plenums
• 500 Ft roll
• Single-stage heat-only or single-stage AC-only thermostats (R + W or R + Y), low-voltage doorbells, chimes, and Class 2 alarm/sensor circuits

Wiring Tip: Standard HVAC thermostat color code is R = 24 V hot from transformer, W = heat call, Y = cool call, G = fan call, C = common (24 V return for thermostat power), O/B = reversing valve on heat pumps. Label both ends of every run during the pull so you don't have to ring out conductors back at the wall plate later.

Plenum Tip: CL2 cable is for general-purpose runs through joists and wall cavities. It is NOT rated for return-air plenums, vertical riser shafts, or commercial drop ceilings used as return-air paths - those require CMP (plenum) or CL2P-rated cable per NEC. Verify the installation environment before pulling cable.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product contains material that the State of California has determined may cause cancer birth defects or other reproductive harm. www.P65Warnings.ca.gov/product