This Gardner Bender battery charging clip is built for heavy-duty charger leads on auto, marine, and lawn-equipment batteries. A toothed jaw grips the battery post or terminal, and the post-style tail at the other end accepts a screw or crimp wire connection on the lead side.

• 50 Amp non-insulated charging clip for battery and test-equipment use
• Toothed jaw on one end, post terminal with crimp wings on the other
• Nickel-plated steel construction for repeated open-close cycles
• Wide jaw fits standard SAE battery posts and heavy bus bars
• 1 clip per card

Tip: Use 50A clips on charger leads that run continuous fast-charge cycles. The 50A rating is for charge current - it is not sufficient for engine cranking current (which can exceed 200A) - use dedicated jumper-cable clamps for jump-starting.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.