This Gardner Bender battery charging clip is built for battery testing and small-load charging applications. A toothed jaw grips the battery post or terminal, and the post-style tail at the other end accepts a screw or crimp wire connection on the lead side.

• 10 Amp non-insulated charging clip for battery and test-equipment use
• Toothed jaw on one end, post terminal with crimp wings on the other
• Nickel-plated steel construction for repeated open-close cycles
• Accepts 16-14 AWG wire at the post via screw or crimp
• 4 clips per card (1 red, 1 black insulator standard mix)

Tip: Use 10A clips for multimeter leads, bench testing, and small 12V accessory hookups. Do not use a 10A clip for vehicle jump-starting - cranking current can exceed 200A and will burn the clip.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.