Bostitch paper-tape collated connector nails sized specifically for joist hangers, hurricane ties, post bases, and other structural metal connectors. The diamond point and full round head are engineered to seat flush in connector nail holes, and the heat-treated, hot-dip galvanized shank gives you both holding power and corrosion resistance for exterior and treated-lumber applications.

• 1-1/2 inch length x .148 inch shank diameter, smooth shank with diamond point
• Full round head, 35-degree paper tape collated
• Thickcoat hot-dip galvanized, heat-treated finish - approved for exterior use and contact with ACQ/CA pressure-treated lumber
• 1,000 nails per box
• Fits Bostitch F33PT, Strapshot MCN-150 and MCN-250, Paslode 5250/65G PP, and Hitachi NR65AK connector nailers
• Size: 1-1/2" x .148", Galvanized

Tip: Always cross-reference the connector manufacturer's spec sheet (Simpson Strong-Tie, USP, etc.) for the required nail diameter and length - the heavier .148 shank carries a higher per-fastener rated load than .131, but the connector hole must be sized for it. For exterior framing, treated lumber, or coastal humidity, stay with galvanized rather than bright. Store sealed in a dry place; paper tape can soften if it gets wet.