ANDERSON METALS LEAD FREE BRASS COMPRESSION CAP - 1/2"

Anderson Metals lead free brass compression cap seals the end of 1/2" copper or compatible tubing. Use it to terminate unused supply lines, blank off branch outlets during remodels, or temporarily isolate a run for pressure testing - all while staying compliant with the federal Safe Drinking Water Act.

• Fits 1/2" OD copper, brass, or soft aluminum tubing with a standard compression nut and sleeve (ferrule)
• Forged lead free brass body, meets Public Law 111-380 (less than 0.25 percent lead weighted average)
• Reusable seal - the ferrule deforms onto the tube but the cap can be removed and reinstalled with a fresh ferrule
• The 1/2" size is typical for branch supply runs to fixtures, hose bibs, and short isolation stubs
• Color: Brass

Tip: Slide the nut and ferrule onto the tubing in the correct orientation before threading on the cap. Hand-tighten the nut, then turn an additional 1/4 to 1/2 turn with a wrench - over-tightening will distort the ferrule and ruin the seal.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to lead a chemical known to the State of California to cause cancer and reproductive harm. www.P65Warnings.ca.gov