Charlotte Pipe Schedule 40 PVC cross fitting provides a four-way slip connection for PVC pressure piping. All four sockets accept standard Schedule 40 PVC pipe and bond with solvent cement for a permanent, leak-tight joint. Used wherever a branch line, main, or header needs to split in two perpendicular directions at the same point - irrigation manifolds, sprinkler header takeoffs, pool and spa plumbing, light commercial water service, and DIY drip system distribution headers.

• 2" nominal size, all slip socket (S x S x S x S)
• Schedule 40 white PVC - rigid, sunlight-resistant when painted or buried
• Sized for main trunk lines, agricultural and commercial irrigation mains, and large pool/spa headers - the largest cross in Charlotte Pipe's common pressure-fitting lineup
• Conforms to ASTM D 1784 (PVC material), ASTM D 2466 (Schedule 40 fittings), NSF 14 and NSF 61 (potable water safety)
• For cold-water pressure systems only - not rated for hot water, drainage (use DWV fittings), or compressed air
• Made in USA

Installation: Cut pipe ends square and deburr the inside and outside edges. Dry-fit and mark each socket for alignment. Apply purple primer to both surfaces, then solvent cement to both, push fully home with a 1/4-turn twist, and hold for 30 seconds. Cure 15-30 minutes before pressure testing in cool weather, 1 hour in cold. Below 40 degrees F, use cold-weather cement.