Madison Mill fluted dowel pins reinforce wood-to-wood joints in furniture, cabinetry, drawer boxes, picture frames, and shelf assemblies. The fluted grooves let glue spread around the pin and let trapped air escape from the bore, producing a tighter, stronger bond than smooth dowels. The 1/2-inch size carries structural loads in chair frames, table legs, and heavy fixtures.

• Diameter x length: 1/2" x 2-1/2"
• Pack: 6 pins per polybag
• Hardwood construction with chamfered ends for easy insertion
• Fluted grooves channel glue and trapped air for stronger bonds
• Carries structural loads in chair frames, table legs, and heavy fixtures
• Use with PVA wood glue and a doweling jig for accurate alignment
• Made in the USA (Ashland City, TN)
• MPN: 9004M

Tip: Drill the receiving hole with a 1/2" bit (same nominal diameter as the pin) roughly 1/16" deeper than half the pin length on each side. Apply PVA glue in the hole and on the pin, then clamp with even pressure until cured -- about 30 minutes for tack and 24 hours for full strength.