Madison Mill fluted dowel pins reinforce wood-to-wood joints in furniture, cabinetry, drawer boxes, picture frames, and shelf assemblies. The fluted grooves let glue spread around the pin and let trapped air escape from the bore, producing a tighter, stronger bond than smooth dowels. The 3/8-inch size is the workhorse for face-frame cabinets, drawer fronts, and chair rails.

• Diameter x length: 3/8" x 2"
• Pack: 18 pins per polybag
• Hardwood construction with chamfered ends for easy insertion
• Fluted grooves channel glue and trapped air for stronger bonds
• Workhorse size for face-frame cabinets, drawer fronts, and chair rails
• Use with PVA wood glue and a doweling jig for accurate alignment
• Made in the USA (Ashland City, TN)
• MPN: 9002M

Tip: Drill the receiving hole with a 3/8" bit (same nominal diameter as the pin) roughly 1/16" deeper than half the pin length on each side. Apply PVA glue in the hole and on the pin, then clamp with even pressure until cured -- about 30 minutes for tack and 24 hours for full strength.