Decorative split escutcheon for covering the gap where a supply or drain pipe penetrates a wall, floor, or ceiling. The two-piece hinged design snaps around the pipe after installation - no need to disconnect fittings or slide the flange on before the pipe was run. Chrome-plated brass body resists humidity, splash, and cleaner spray in bathrooms, laundries, and exposed-supply kitchens.

• Pipe size: 3/4" - fits standard iron pipe (IPS) or matching copper tube outside diameter
• Two-piece hinged split design - snaps around in-place pipe
• Polished chrome plating over brass body
• Use at floor, wall, or ceiling pipe penetrations
• Friction-fit; no tools required for installation
• Conceals out-of-square cutouts and rough wall openings

Installation Tip: Slide the open flange around the pipe at the penetration, then press the two halves together until the hinge clicks closed. For a tighter hold on slightly oversized cutouts, a bead of clear silicone behind the flange where it meets the wall keeps it from rotating on the pipe and seals against splash at sink and tub penetrations.

Sizing Note: Split flanges are sized by nominal pipe size - the same way the pipe itself is sized. A 1/2" supply line takes a 1/2" flange. If the pipe was wrapped with insulation or rust-protection tape that increased its visible diameter, step up to the next size.