The SnapToggle is the high-strength replacement for traditional wing toggles - it holds roughly twice the load in a smaller drilled hole, and the metal channel snaps and locks in place behind the wall so the bolt can be backed out and re-installed without losing the anchor. Use for hanging shelves, mirrors, grab bars, cabinets, TV mounts, and other heavy loads on hollow walls. The 10-pack is sized for installers running multiple anchors on the same job.

• Thread size: 3/16"-24 UNC machine thread
• Bolt length: 2"
• Drilled hole size: 1/2" (standard spade or twist bit)
• Grip range: 3/8" to 3-5/8" total wall thickness
• Anchor material: Zinc-plated steel channel + nylon strap legs
• Ultimate load in 1/2" drywall: 238 lb
• Ultimate load in 5/8" drywall: 356 lb
• Compliance: Federal Specification FF-B-588-D Type V
• Pack count: 10 anchors with bolts (contractor / installer pack)

Installation Tip: Drill the 1/2" hole, fold the metal channel along the strap legs, push it through the hole, and pull the strap toward you so the channel rests flat against the back of the wall. Slide the plastic cap down the strap until it sits flush against the wall, then snap the strap legs off at the cap. Thread the bolt through whatever you are hanging into the channel and tighten.

Reusability Tip: Unlike wing toggles, the metal channel stays in place when the bolt is backed out - you can remove and re-install the bolt indefinitely without re-drilling or losing the anchor behind the wall.