16-gauge angled finish nails with a galvanized finish for corrosion resistance in interior trim and protected exterior trim work. Designed for 20-degree angled finish nailers from DeWalt and other major brands that accept angled-magazine 16-gauge nails.

• Length: 2"
• Gauge: 16 (approx. 0.0625" shank diameter)
• Collation: 20-degree angled, paper-tape collated
• Finish: Galvanized for corrosion resistance
• Head: Small T-head sits flush or just below the surface for easy filling
• Drives consistently in 16-gauge angled finish nailers (DeWalt, Bostitch, Senco, and other 20-degree pattern nailers)
• Quantity: 2,500 nails per box

Selection Tip: Use for thicker trim or anywhere you need extra holding power - built-up baseboard, crown molding, stair tread, and exterior door casing. Standard length when fastening 5/8" to 3/4" stock into framing.

Use Tip: Set nailer depth on a scrap of the same material first - 16-gauge nails leave noticeable holes if driven too proud, and they bend if driven too deep into hardwood. Aim for the head to sit just flush or about 1/32" below the surface, then fill with matching putty.