Ali Industries Gator 6212GA is a 15-pack of 80-grit (Medium) silicon carbide floor sanding sheets pre-cut for 12" x 18" orbital floor sanders. Standard fit for the U-Sand, Clarke, EZ8, American Sanders, and other rental orbital floor sanders. Silicon carbide cuts hardwood, softwood, and cured floor finishes faster and cleaner than aluminum oxide.

• 80 grit, Medium -- final smoothing before stain or seal on a refinished floor, and sanding between finish coats on hardwood
• Silicon carbide grain -- sharper and harder than aluminum oxide; cuts urethane and shellac cleanly without loading
• Heavy-duty combination paper backing stands up to the torque and heat of orbital floor sanders
• Self-adhesive back -- peel and stick, no clamps or hook-and-loop pads required
• 12" x 18" pre-cut format fits standard rental and professional orbital floor sanders
• Waterproof paper -- can be used wet or dry for reduced dust and finer scratch pattern on finish coats
• A 15-pack per package

Use Tip: 80 grit is the last pass before stain or seal on most residential floors. Vacuum thoroughly and wipe with a tack cloth before finish -- any dust in the pores will telegraph through the topcoat.

Care Tip: Keep the peel-off backing dry until you're ready to apply -- moisture weakens the adhesive. Between grit changes, blow dust off the sander pad so the next sheet seats flat and doesn't tear at the corners.