National Hardware V238 series kickdown door stop holds an open door in place and protects the wall behind the knob. Foot mounts to the base of the door; a kick of the toe drops the spring-loaded leg down to the floor where the ribbed rubber pad grips against the surface. Lift the toe to release and the spring returns the leg to the stowed position. Die-cast zinc body with matte black finish; mounting screws included.

• Length: 4"
• Body: die-cast zinc
• Finish: matte black
• Foot: ribbed rubber pad for positive floor grip
• Mechanism: spring-loaded; kicks down to hold, lifts to release
• Mounting: two screws into door panel (hardware included)

Installation Tip: Mount on the lock-side edge of the door, 3" to 4" from the bottom corner so the rubber pad reaches the floor cleanly when deployed. Open the door to the desired hold position before drilling - the leg should land on bare floor or a flat threshold, not a transition strip or area rug. Pilot-drill the screw holes in hardwood doors; in hollow-core or metal-skin doors, use a backing block or sheet-metal screws so the stop has something to bite into.

Finish Selection Tip: Matte black is the headline modern and farmhouse finish that coordinates with matte-black knobs, hinges, lighting, and plumbing - currently the most-requested trim color in new-construction interiors. The matte powder coat hides fingerprints better than gloss black and resists glare. Step over to brass for warm traditional packages; step to satin chrome or white for older finish ecosystems where matte black would read as a one-off.

Note: The rubber pad relies on friction against the floor surface, so the stop works best on bare hardwood, tile, vinyl, sealed concrete, or low-pile carpet. On very smooth polished marble or freshly waxed hardwood the foot may slide; on deep-pile carpet the leg may not reach the floor at all. For frequent commercial-traffic use or heavy storm doors, step up to a wall-mounted hinge-pin or baseboard-mounted stop.