Threaded 45-degree malleable iron elbow for changing direction in galvanized steel pipe runs without the sharp pressure drop of a 90. Hot-dip galvanized inside and out for corrosion resistance in water, air, and exposed exterior service. Female NPT threads on both ends.

• Pipe size: 2-1/2" FIP x 2-1/2" FIP
• Angle: 45 degrees
• Malleable iron per ASTM A197
• Hot-dip galvanized zinc coating per ASTM A123
• Threads, dimensions, and pressure ratings meet ANSI B16.3, B16.14, and B1.20.1
• Pressure tested to 150 PSI

Tip: Galvanized fittings are rated for water, air, and non-flammable gas - they are not approved for natural gas or propane in most jurisdictions; use black malleable iron for gas. Use pipe dope or PTFE tape rated for the service when threading up.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.