Milescraft coarse-thread pocket hole screws with T20 Star (Torx) drive. The T20 drive resists cam-out far better than Phillips or slotted heads, allowing higher torque without damaging the screw head or your driver bit. Coarse threads are engineered for softwoods, plywood, and MDF.

• 1-1/4" length, zinc-coated steel for corrosion resistance
• T20 Star (Torx) drive resists cam-out
• Washer Head for solid bearing inside the pocket
• Self-tapping point - no pilot hole required
• Coarse thread for softwoods, plywood, and MDF
• 100 screws per box

Best For: 5/8" to 3/4" stock. The most popular pocket hole length - standard for 3/4" plywood face frames and dimensional lumber.

Tip: Compatible with Milescraft PocketJig systems and other standard pocket hole jigs. Use a T20 driver bit (not included with these screws). For indoor use only - the zinc plating is not rated for exterior or wet-location service.