National Hardware bar-type utility pull with rounded bow profile for comfortable grip on screen doors, drawer fronts, tool chest lids, shed doors, gates, and equipment lockers. Stamped steel body with bright zinc plating for corrosion resistance in dry exterior and unheated outbuilding settings; mounting screws included.

• Overall length: 5-3/4"
• Projection from mounting surface: 1-3/8"
• Body: stamped steel
• Finish: bright zinc plating (silver)
• Mounting hardware: two wood screws included
• Use on: wood or metal doors, drawer fronts, tool chest lids, screen doors, gate panels, shed doors, equipment lockers, large drawers

Installation Tip: Position the pull at a comfortable hand height for the application - typically 36" to 42" off the floor for screen and shed doors, or centered on drawer or lid faces. Mark and pilot-drill both screw holes through the panel; oversize pilots slightly in hardwood and use sheet-metal screws instead of the supplied wood screws on steel doors. For panels thicker than 1-1/2" or for pulls that will see heavy daily use, step up to longer #10 wood screws so the pull anchors into structural framing rather than just the door skin.

Finish Selection Tip: Zinc plating is the workhorse outdoor finish for sheds, barns, and detached garages where the pull sees occasional rain but not constant salt or wash-down exposure. Step up to galvanized for full outdoor weather or to brass/black/white for visible interior and entry-door applications where appearance leads selection.

Note: Rated for hand-pull operation, not as a load-bearing carry handle. For luggage, tool, or equipment cases that will be lifted by the handle, step up to a load-rated chest handle line.