This lead free brass reducing coupling steps 1" PEX tubing down to 3/4" PEX tubing in a single straight fitting. Use it for branch transitions off a 1" trunk line down to a 3/4" fixture supply, manifold-to-fixture step-downs, and PEX-to-polybutylene conversions where the existing pipe size does not match the new run.

• Lead free brass construction certified safe for potable drinking water (meets the 0.25% lead-content rule per the Reduction of Lead in Drinking Water Act)
• Reduces from 1" PEX to 3/4" PEX in one straight fitting
• Works on hot and cold water supply, hydronic radiant heat, and PEX-to-polybutylene transitions
• Compatible with standard PEX tubing brands (Uponor, Viega, SharkBite, Apollo, Zurn, Watts)
• Crimps with copper rings per ASTM F1807 or stainless cinch clamps per ASTM F2098 (use the ring sized for the matching tubing OD on each side)
• Brass body resists corrosion, mineral scale, and pipe-stress cracking far better than push-fit plastic alternatives

Tip: A reducing coupling has two different barb diameters - confirm which side is which before cutting your tubing. Cut PEX square with a dedicated PEX cutter, slide the correctly-sized crimp ring or cinch clamp onto each side (1" ring for the 1" side, 3/4" ring for the 3/4" side), push each tubing end fully onto its barb until it bottoms out, then crimp roughly 1/8" to 1/4" from the end. Verify each crimp with a go/no-go gauge before pressure-testing.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to chemicals including Lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov.