MIDSTATES PLASTICS MIX N' MEASURE CONTAINER - 2-1/2 QTHeavy-duty polypropylene measuring container for mixing paint, primer, stain, epoxy, gelcoat, adhesives, and finishing products. Dual graduations (ounce and metric) printed up the wall let you measure components directly in the mix cup, and a wide flat bottom keeps the cup stable on the bench while you stir.
- Size: 2-1/2 Qt (80 fl oz / approximately 2,366 mL)
- Graduations: Dual ounce and metric (mL) scales molded up the wall for direct in-cup measuring
- Bottom: Wide flat profile for stable stirring without spinning the cup
- Material: Solvent-resistant polypropylene - compatible with lacquer thinner, acetone, MEK, mineral spirits, naphtha, alcohol, and common auto and finishing solvents
- Applications: Paint, primer, stain, epoxy and polyester resin, gelcoat, two-part adhesives, paste mixing
- Packaging: Sold each
Tip: 2-1/2 Qt (80 fl oz) is sized for vehicle-section paint mixes (door, hood, single fender), large epoxy resin pours for table tops and pours-in-place, and large adhesive batches for tile or panel installation. For two-part paints and epoxies, measure the base component first to the lower mark, then add hardener to the upper mark - stirring with a flat stir stick along the bottom corner for at least 60 seconds ensures the hardener reaches the resin sitting against the wall. Discard the cup after each pot life cures rather than scraping and reusing; trapped cured resin contaminates the next mix.