Change direction in a 3" PVC line by 45 degrees with this Schedule 40 elbow from Charlotte Pipe. Manufactured in the USA, this fitting meets strict quality standards for pressure applications in irrigation, sprinkler systems, and cold water supply lines.

• 3" slip x slip connection for joining same-size pipe
• 45-degree turn (1/8 bend) for gentler flow than a 90-degree elbow
• Schedule 40 PVC rated for pressure applications up to 140 deg F
• Conforms to ASTM D 1784, ASTM D 2466, NSF 14, and NSF 61 standards
• Made in the USA by Charlotte Pipe
• Sized for large drain runs and main building supply offsets where Schedule 40 pressure rating is required.

Tip: Cut pipe square, deburr the inside and outside edges, then use PVC primer followed by solvent cement for a permanent, leak-proof bond. Allow proper cure time before pressurizing the system.