Concentric hub x hub reducer coupling for transitioning between 1-1/2" and 2" PVC DWV pipe in a single fitting. Schedule 40 wall thickness and solvent-welded sockets give the joint the same strength as the surrounding pipe, so the size change does not become the weak point in a stack or branch.

• Connection: 1-1/2" hub x 2" hub (solvent-weld socket both ends)
• Schedule 40 PVC, white
• Concentric (centerline-aligned) reduction
• Dual rated to ASTM D1785 (pressure) and ASTM D2665 (DWV)
• NSF listed
• Non-pressure DWV service; maximum operating temperature 140 deg F
• Made in the USA

Applications: Step a 1-1/2" trap arm or vent up to a 2" branch drain, tie a 1-1/2" lavatory or shower drain into a 2" horizontal main, or transition between 1-1/2" and 2" piping at a vent riser.

Installation tip: In a vertical orientation the concentric profile is fine. On a horizontal drain run, code (IPC/UPC) requires an eccentric (flat-top) reducer to keep solids moving - this concentric reducer is acceptable on vents and on vertical drain segments but should be swapped for an offset / flat-top reducer if used in a horizontal sanitary drain. Cut square, deburr, dry-fit, primer (purple), medium-bodied PVC cement, push together with a quarter turn, hold ten seconds.

Note: Not for use with hot-water distribution, compressed air, or fuel gas. For above-ground sanitary drainage only.