American-made Wilde Tool hard cap pry bar for prying, lifting, nail-pulling, and light demolition. Forged from square stock steel with a black oxide bar coating that shrugs off rust. The steel cap on the handle end sits flush with the bar so you can drive it with a hammer to start a pry or seat the chisel tip without mushrooming the handle.

• Overall length: 17"
• Exposed bar: 12"
• Handle length: 5"
• Square stock steel construction
• Bent chisel tip for prying leverage
• Hard cap handle (flush steel end cap) - take direct hammer strikes
• Black oxide bar coating for rust resistance
• Made in USA

Best for: tight-quarters prying, trim and molding removal, light demolition, and detail work where a longer bar will not fit

Tip: Slide the chisel tip in with light hammer taps on the hard cap, then pull on the handle - the cap is sized for hammer strikes and the bend in the tip gives you mechanical advantage without slipping out.