The Milwaukee #1 step drill bit produces 13 clean hole sizes from 1/8" to 1/2" in 1/32" increments, replacing a dozen separate twist bits when drilling thin steel, aluminum, copper, and plastic. The dual-flute geometry chips fast, the Rapid Strike tip self-starts without a punch mark and runs cooler than a single-point bit, and the 3-flat Secure-Grip shank locks into a standard drill chuck without spinning under load.

• 13 steps from 1/8" to 1/2" in 1/32" increments
• Drills sheet steel, aluminum, copper, brass, and plastic up to roughly 1/8" thick
• Dual-flute design clears chips fast and cuts cooler than single-flute step bits
• Rapid Strike tip self-starts and runs cooler, prolonging cutting-edge life
• Laser-engraved size marks on each step for quick identification
• Black oxide coating reduces friction and resists corrosion
• 3-flat Secure-Grip shank locks into standard 3-jaw and quick-change chucks

Application Tip: Step bits are the right tool for thin material -- up to about 1/8" thick. Use the high speed setting on a cordless drill, apply firm steady pressure, and stop drilling the moment the next step's shoulder reaches the workpiece. For sheet metal, a few drops of cutting oil cool the tip and produce a cleaner hole edge.

Selection Tip: The #1 covers the small-hole range used for switch screws, sheet-metal screws, pop rivets, and small grommets. Pick a higher-numbered Milwaukee step bit (#3, #4) when you need 1/2" to 7/8" conduit-knockout sizes.